Study of voltage sag in power system with six-phase transmission line

Voltage sags are the short durations in root-mean-square (RMS) rated AC voltage occur during faults may cause miss-operations to the customer’s equipment and loads of power system and recognized as the most important power quality problem. However, this thesis investigate the sag event which is caus...

Full description

Bibliographic Details
Main Author: Wan Mohd Afiq Nazman, Wan Anuar
Format: Undergraduates Project Papers
Language:English
Published: 2008
Subjects:
Online Access:http://umpir.ump.edu.my/id/eprint/356/
http://umpir.ump.edu.my/id/eprint/356/
http://umpir.ump.edu.my/id/eprint/356/1/WAN_MOHD_AFIQ_NAZMAN.pdf
id ump-356
recordtype eprints
spelling ump-3562015-03-03T06:16:44Z http://umpir.ump.edu.my/id/eprint/356/ Study of voltage sag in power system with six-phase transmission line Wan Mohd Afiq Nazman, Wan Anuar TK Electrical engineering. Electronics Nuclear engineering Voltage sags are the short durations in root-mean-square (RMS) rated AC voltage occur during faults may cause miss-operations to the customer’s equipment and loads of power system and recognized as the most important power quality problem. However, this thesis investigate the sag event which is caused by short circuit (three-phase-to-ground fault and six-phase-to-ground fault) on the double three phase transmission line and conversion of phase double circuit to the six phase single circuit transmission line. Six phase were chosen for this project because six phase enhance power transfer capability and becoming the area of growing interest in the power system industry. This thesis also presents the comparisons between voltage reductions at the terminal bus for both three and six phase cases. Simulation at steady state and transient state of the system proposed is simulated using PSCAD/EMTDC. The system that used in this thesis was four buses transmission line. The simulation result shows that converted double three phase to six phase transmission experienced lower voltage sags level at other bus terminal than double three phase system due to three-phase-to-ground fault and six phase-to-ground fault if the fault happen at bus three, but for faulted bus, the it’s experienced the same percentage voltage sag. For fault happen between transformers in six phase operation, 20% to 45% of the voltage was improve at the faulted bus compare to three phase system. 2008-11 Undergraduates Project Papers NonPeerReviewed application/pdf en http://umpir.ump.edu.my/id/eprint/356/1/WAN_MOHD_AFIQ_NAZMAN.pdf Wan Mohd Afiq Nazman, Wan Anuar (2008) Study of voltage sag in power system with six-phase transmission line. Faculty of Electrical & Electronic Engineering, Universiti Malaysia Pahang. http://iportal.ump.edu.my/lib/item?id=chamo:38420&theme=UMP2
repository_type Digital Repository
institution_category Local University
institution Universiti Malaysia Pahang
building UMP Institutional Repository
collection Online Access
language English
topic TK Electrical engineering. Electronics Nuclear engineering
spellingShingle TK Electrical engineering. Electronics Nuclear engineering
Wan Mohd Afiq Nazman, Wan Anuar
Study of voltage sag in power system with six-phase transmission line
description Voltage sags are the short durations in root-mean-square (RMS) rated AC voltage occur during faults may cause miss-operations to the customer’s equipment and loads of power system and recognized as the most important power quality problem. However, this thesis investigate the sag event which is caused by short circuit (three-phase-to-ground fault and six-phase-to-ground fault) on the double three phase transmission line and conversion of phase double circuit to the six phase single circuit transmission line. Six phase were chosen for this project because six phase enhance power transfer capability and becoming the area of growing interest in the power system industry. This thesis also presents the comparisons between voltage reductions at the terminal bus for both three and six phase cases. Simulation at steady state and transient state of the system proposed is simulated using PSCAD/EMTDC. The system that used in this thesis was four buses transmission line. The simulation result shows that converted double three phase to six phase transmission experienced lower voltage sags level at other bus terminal than double three phase system due to three-phase-to-ground fault and six phase-to-ground fault if the fault happen at bus three, but for faulted bus, the it’s experienced the same percentage voltage sag. For fault happen between transformers in six phase operation, 20% to 45% of the voltage was improve at the faulted bus compare to three phase system.
format Undergraduates Project Papers
author Wan Mohd Afiq Nazman, Wan Anuar
author_facet Wan Mohd Afiq Nazman, Wan Anuar
author_sort Wan Mohd Afiq Nazman, Wan Anuar
title Study of voltage sag in power system with six-phase transmission line
title_short Study of voltage sag in power system with six-phase transmission line
title_full Study of voltage sag in power system with six-phase transmission line
title_fullStr Study of voltage sag in power system with six-phase transmission line
title_full_unstemmed Study of voltage sag in power system with six-phase transmission line
title_sort study of voltage sag in power system with six-phase transmission line
publishDate 2008
url http://umpir.ump.edu.my/id/eprint/356/
http://umpir.ump.edu.my/id/eprint/356/
http://umpir.ump.edu.my/id/eprint/356/1/WAN_MOHD_AFIQ_NAZMAN.pdf
first_indexed 2023-09-18T21:52:28Z
last_indexed 2023-09-18T21:52:28Z
_version_ 1777413860622336000