A study on the effect of slenderness ratio on concrete filled steel column compressive strength / Oswald P Moloyos
The use of circular steel column sections coupled with concrete infill has been used on various building projects with great advantage such as high axial load capacity and favorable ductility performance. From a point of view, the circular steel columns can serves as formwork for the concrete inf...
| Main Author: | |
|---|---|
| Format: | Student Project |
| Language: | English |
| Published: |
Faculty of Civil Engineering, Universiti Teknologi MARA
2006
|
| Subjects: | |
| Online Access: | http://ir.uitm.edu.my/id/eprint/26113/ http://ir.uitm.edu.my/id/eprint/26113/1/PPb_OSWALD%20P%20MOCOYOS%20EC%20P%2006_5.pdf |
| Summary: | The use of circular steel column sections coupled with concrete infill has been used on
various building projects with great advantage such as high axial load capacity and
favorable ductility performance. From a point of view, the circular steel columns can
serves as formwork for the concrete infill during construction, which makes concrete
filled steel columns more economical than reinforced concrete columns.
Compressive strength is one of the important properties of concrete. The strength in
compression has a definite relationship with all the other properties of concrete. It means
to say that, the other properties are improved with the improvement in the compressive
strength.
The purposes of this study are to check the slenderness ratio and the strength of the
concrete filled steel column (CFSC). The concrete mix was prepared according to the
British Standard 5328; 1981. For the steel hollow section the length was varied as
450mm, 600mm, 750mm and 900mm. The concrete characteristic strength that will be
used is grade 50 (50N/mm2) with the elastic modulus 46.38GPa and the elastic modulus
for the steel is 218GPa.
The behavior of column concrete-filled circular hollow sections (CHS) subjected to axial
load was investigated experimentally. A total of 12 specimens were studied. The quantity
L/r is called the slenderness ratio of the column. It is clear, that the minimum value of the
radius of gyration, r should be used in computing the slenderness ratio. It will also
provide a more realistic view of the relation between the slenderness ratio of a column
and the load that causes it to fail. |
|---|