Tool wear and surface roughness aspects in heat assisted end milling of AISI D2 hardened steel
With the advent of several advanced difficult-to-cut materials, and with the availability of heat resistant tool materials has posed a great challenge in industries. Hardened steel is one of these difficult-to-cut materials. During the last few decades numerous studies have been conducted to impr...
| Main Authors: | , , |
|---|---|
| Format: | Book Chapter |
| Language: | English |
| Published: |
IIUM Press
2011
|
| Subjects: | |
| Online Access: | http://irep.iium.edu.my/23584/ http://irep.iium.edu.my/23584/ http://irep.iium.edu.my/23584/4/chp5.pdf |
| Summary: | With the advent of several advanced difficult-to-cut materials, and with the availability of heat
resistant tool materials has posed a great challenge in industries. Hardened steel is one of these
difficult-to-cut materials. During the last few decades numerous studies have been conducted to
improve the machinability of these materials and many large organizations have invested
considerably in exploring and developing new techniques to minimize machining costs of these
materials while maintaining their quality requirements. The benefits for the manufacture of
components from hardened steel are substantial in terms of reduced machining costs and lead
times, in comparison to the more traditional route which involves machining in the annealed
state, heat treatment, grinding or electrical discharge machining (EDM), and manual finishing
[1]. Recent advances in cutting tool and machine tool technologies have opened up new
opportunities for investigation in machining hard materials and especially for bulk removal of
material. For these reasons the growing interest for hot machining process is being developed in
industry. In this method work-piece is softened by heating and thereby shear strength is reduced
[2]. The technology of hot machining is not new. Previous generations of this technology
employed low-grade heat sources such as flame, electrical resistance, induction and plasma arcs
[3]. Ozler et al. [4] integrated plasma gas heating in turning of austenitic manganese steel and he
noticed that tool life increases when heating temperatures increased.
Preheating of workpiece by induction heating has been recently reported to enhance the
machinability of materials. The latest current work done by Amin et al [5] when he carried out
preheated induction heating in end milling of AISI D2 hardened steel using Poly Crystalline
Cubic Boron Nitride (PCBN) inserts. He observed that preheated machining of the material leads
to surface roughness values well below 0.4 μm, such that the operations of grinding as well as
polishing can be avoided at the higher cutting speeds. He added that preheated machining has
been able to reduce the amplitude of the lower frequency mode of chatter by almost 4.5 times at
the cutting speed of 50 m/min. The primary causes of this stable cutting need to be studied in the
perspective of material properties and damping capability of the material in the preheated
condition. The primary objective of preheating is to enhance the ductility of the material for
easier chip formation and better chip flow over the rake surface of the tool. In addition
preheating is expected to improve the tool life and improve surface finish of the machined components. But preheating may lead to softening of the hardened workpiece.. Hence, in the
present study an attempt has been made to carry out an investigation in hot machining of end
milling operation of AISI D2 hardened steel using induction heating. To discern differences in
machinability, the test workpieces were machined with higher range of temperature from 250-
450 °C. |
|---|